Time to see if it fits. Carefully carried in, in two parts (the tall/rear unit is a separate part).
Most of it’s inside the house now. Still quite a bit to build.
Still having fun with a seeming slight difference in part length.
I thought this was an issue (the difference in placement of the holes, from the lower edge). I emailed Evo and it’s by design, i.e. to cause the unit to open when a slight twist to avoid the side of the adjacent tall unit.
The drawer doesn’t want to stay on it’s rails, some adjustment needed I think.
The rear roof unit (above the rear seat).
All mocked up in line, looking good!
Decided to move into the lounge, much warmer than in the garage.
Test fitting two parts of the lower unit.
Seem’s that there’s a slight issue with an inconsistent gap from front to back on this part, will have to investigate this further.
The assembly is continuing well, the lower section is almost complete now. Instructions hung-up so they’re easy to refer to.