Wiring, sockets, switches etc. & a bit of furniture too

Cutting of the front panel for the rear seat/bed.Test fitting in place.Preparing the mountings for the 12V charger, fuses, main switch etc.  This is all going to fit vertically on the offside of the rear seat frame.Since I don’t know how warm the charger will get I’ve decided to mount it offset from the panel and also cover the panel with a thin sheet of metal.This is the rear part of the panel in place.  You can see the trunking I have installed which enables the tidy routing of cables from from fuse box.Forward part of the panel in place now.These are the wires for the light switches and also a 12V supply for a USB socket.The level gauge for the LPG tank.Wiring for the LPG level gauge, soldered for reliability (since it’ll be hard to access later).Cabling to where the fusebox is going to be located.Route from the lower unit to under the seat/bed.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.